Power Measurement; Channel-Frequency Operating Mode - Promax 8 SE Mode D'emploi

a) THRESHOLD
It defines the minimum level to show channel on the display (OFF or between 21
and 120 dBµV). If the threshold is deactivated (OFF), on the SCAN representation
will appear all the active channels of the channel plan with a level higher than
20 dBµV. Otherwise, if we define a level for the THRESHOLD parameter,
channels with a level lower than the threshold value will not be displayed.
b) REFERENCE LINE
It permits to activate or to deactivate (OFF) a reference line on the SCAN graph
(between 21 and 120 dBµV). This reference line allows to establish judgements of
channel level acceptance just with a glance at the SCAN screen.
c)

POWER MEASUREMENT

It allows to define if the measurement of the power is carried out on the channel
bandwidth (CHAN) indicates by the MARKER or over the full band between 5 and
863 MHz (∑PWR).
To leave the SCAN operating mode configuration menu, just press the key of the
operating mode you wish to access.

4.2.3 CHANNEL-FREQUENCY operating mode

The CHANNEL-FREQUENCY
measurements:
Analogue channels:
Digital channels:
To access to this mode of operation, press the CH-FR key [10].
There exist two tuning modes: by channel or by frequency. To switch
between these two modes of tuning, press successively the CH-FR key [10].
Page 20
operating
- Video carrier level.
- Carrier / Noise (C/N) ratio.
- Video / Audio (V/A) ratio.
- Audio Carrier Level.
- CSO-CTB intermodulation distortion measurement.
- Channel power by measurements integration.
- Carrier / Noise (C/N) ratio.
USER'S MANUAL. PROMAX-8
IMPORTANT
mode provides the
SE
following
07/2011