Safety Instructions Relating Specifically To The Equipment - Meister MHG2000-2 Manuel D'utilisation Original

adjustments, changing accessories,
or storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to oper­
ate the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
b To avoid hazards, damaged power
leads must be replaced by the manu-
facturer or his customer service rep-
resentative.
MW-5460520-Bedien-2008.indd 33 MW-5460520-Bedien-2008.indd 33
6 – Safety instructions
relating specifically
to the equipment
• When carrying out work in which dust
is generated, wear a face mask and
safety goggles - do not smoke and
avoid naked flames.
• Make sure that the switch is in the 0
position before putting the plug in the
socket.
• The nozzle gets very hot. Always wear
gloves and safety glasses.
• Never use the hot-air gun as a hair
drier.
• Never direct the hot-air flow at people
or animals.
• Do not use in an atmosphere prone to
explosion.
• After use, set down the device on the
stand and allow it to cool before put-
ting it away.
• Do not use the hot-air gun near easily
flammable materials or gases.
• Never obstruct the hot-air flow.
• To cool the hot-air gun, always place
it in an upright position (fig. 2) or hang
it up by the bracket provided.
• Never use the hot-air gun in a wet
environment or in areas with a high
degree of humidity (e.g. bathrooms,
saunas etc.).
33
18.08.20 12:37 18.08.20 12:37