Össur RHEO KNEE 3 Mode D'emploi page 11

• Operating humidity: 5% to 95% relative humidity (non-condensing)
• Manufacturer: UE Electronic
• Model No.: UE24WCP-240100SPA
ELECTROMAGNETIC COMPATIBILITY PRECAUTIONS
SAFETY PRECAUTIONS
Because of electromagnetic compatibility (EMC) special precautions need to be taken with the device:
• The device should not be used adjacent to or stacked with other equipment. In case adjacent or stacked use is
necessary, the device should be checked to make sure it operates normally.
• The device can be susceptible to electromagnetic interference from portable and mobile RF communications
devices such as mobile (cellular) phones.
• The device can be susceptible to interference from other equipment, even if the equipment complies with
CISPR EMISSION requirements.
MAINTENANCE
The unit should be sent to Össur for repairs or service. No other company or individual is allowed to service or
repair the unit in any way.
Before sending the device for repairs or service, make sure that the operating instructions have been followed
accurately. Immediately after exposure to water the device may emit slight noise during use.
CLEANING
• Clean the knee with a damp cloth and mild soap or isopropyl alcohol when needed. Dry the product with a lint-
free cloth and allow it to dry fully.
• DO NOT use solvents stronger than isopropyl alcohol.
• DO NOT use compressed air to clean the knee, as it can cause the knee to malfunction and deteriorate
prematurely.
LIABILITY
The manufacturer recommends using the device only under specified conditions and for the intended purposes.
The device must be maintained and used according to the instructions for use. The manufacturer is not liable for
damage caused by disregard of this document, particularly due to improper use or unauthorized modification of
the device.
CE CONFORMITY
This device meets the requirements of the 93/42/EEC guidelines for medical devices. This device has been
classified as a class II device according to the classification criteria outlined in appendix IX of the guideline.
WARRANTY
For information on warranty, please see the Warranty Card
COMPLIANCE
This component has been tested according to ISO 10328 standard to three million load cycles. Depending on the
amputee's activity this corresponds to a duration of use of three to five years. We recommend carrying out regular
yearly safety checks
ISO - P - kg *)
*) Body mass limit not to be exceeded!
For speci c conditions and limitations of use see
manufacturer's written instructions on intended use!
11