Machine Operation; Setting The Cleaning Controls - Numatic TGB 6055/100 Notice Originale

Table des Matières

Publicité

Raising/Lowering
the Floor Tool
After preparing the floor (see previous
section), we are now ready to set the
controls to suit the cleaning conditions.
Before any settings can be applied,
ensure the brush deck is lowered. Move
the floor tool lever to its lower position.
NOTE: Do not pull the machine
backwards with the floor tool in the
lowered position, this could possibly
damage the blades.
Raising/Lowering the Brush Deck
The control for lowering the brush deck can be found to the rear right of the machine.
Lower the brush deck by moving the left hand release lever to the upper position.

Setting the Cleaning Controls

Using the control handle with both hands, push the machine forward.
The battery charge level meter will illuminate for 5 seconds. (Fig. 1)
Switch on the Water Flow Rate (Fig. 2), and vacuum pick up (Fig. 3).
1
2
o

Machine Operation

3
o
T 01460 68600
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tgb 6055/100t

Table des Matières