Numatic TGB 6055/100 Notice Originale page 7

!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF ALL
TGB 6055/100 CONTENTS
● 2 x Ignition Keys ● 2 x 40 Amp Fuse
(Battery) ● 1 x 30 Amp Fuse (Brush)
● 1 x 20 Amp Fuse (Vac)
● 1 x 2.5 Amp Fuse ● Maxi Fuse-puller
For Charger-less Model,
all the above plus:
● 1 x Charger Connector ● 2 x Charger
Connector Terminals
● 4 x Battery Terminal Connector
covers ● 1 x Fuse Holder
Lift top tank assembly to reveal battery
compartment, ensuring you use the handle
grip provided.
Fit battery fuse (contained in start-up pack)
into the battery fuse holder as illustrated.
(Fig. 1, 2, 3.)
Insert Key into ignition located on the
control panel (See below (Fig. A)
NOTE: Wear suitable gloves when
inserting fuses.
1
Ensure that no metal objects come into contact with
battery terminals while the batteries are exposed.
When inserting the first fuse you may notice
a spark, this is normal.
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
2
Insert the Ignition key and
A
switch the machine on.
(Fig. A)
Using the control handle with both hands,
When the machine is removed and in a safe position,
Note: Do not pull the RED trigger handle while in
During vehicular transportation ensure the product
is secured to avoid unnecessary movement.
Use handle grip when
raising or lowering the
top waste-tank.
slowly push the machine off the pallet.
release the control handle.
transport mode (Fig. B)
Machine Set-up Guide
Fuse Location
3
B
T 01460 68600
!
7