Regular Maintenance - Numatic ET 4045 Mode D'emploi

!
The TT / ET Range has been designed with ease of use in mind, this included
easy stripping-down and cleaning.
After use, empty waste-water tank using emptying hose and flush out with
clean water (Fig.19).
Fig.20
Fig.22 Fig.23
Remove the filter fitted into the separator and flush with clean water (Fig.22)(Fig.23).
Placed into the top tank is grey filter basket, clean and flush with clean water (Fig.24) (Fig.25).
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
Fig.21
The Bottom (Clean Water) tank is attached to the chassis and should only
be removed by a competent service engineer (Fig.26).
Clean by flushing with clean water if required.
Excess water can be drained using the clear dump hose fitted to the rear
of the machine.
Located under the left hand side is a clean water filter, ensure the clean
Fig.26
water tap is turned off before removing this filter (Fig.27).
Clean and flush with clean water if required.

Regular Maintenance

Remove the two hoses to disconnect the separator from the
machine (Fig.20).
Lift off the separator. The separator has a sealing-rubber
which should be examined at every clean-down (Fig.21).
Rinse using clean water.
Fig.24
28
!
Fig.19
Fig.25
Fig.27