Regular Maintenance - Numatic TT 516 Mode D'emploi

!
ALWAYS ENSURE THAT THE POWER SUPPLY IS DISCONNECTED,
The TT 516 has been designed with ease of use in mind, this included easy stripping-down and cleaning.
Fig 28
Fig 30
Remove the two filters clipped into the separator and flush with clean water (Fig 30)(Fig 30a).
Replace by fitting the rear of the filter first then clipping the front to lock in place (Fig 31) (Fig 32).
PRIOR TO ANY MAINTENANCE OPERATION.
A
Remove the two hoses and disconnect the
separator from the machine (Fig 28). Undo
the separator restraining strap (Fig 28a) and
lift off the separator. The separator has a
sealing-rubber which should be examined at
every clean-down (Fig 29).
Rinse using clean water.
Fig 28a
Fig 30a
Once emptied the top waste-water tank can simply be lifted off. (Fig 33).
Fig 33
The clean-water tank can be drained via the yellow cap fitted to the left
hand side of the machine. The cap has a rubber seal and might require a
spanner to remove. (Fig 34).
NOTE:
Fig 34

Regular Maintenance

After use, empty waste-water tank using
emptying hose and flush-out with clean
water.
Fig 31
Avoid over tightening the clean water draining cap.
10
A
Fig 32
!
Fig 29