Regular Maintenance - Numatic TT 516B Notice Originale

!
The TT1840 has been designed with ease of use in mind, this included easy stripping down and cleaning.
26
28
Remove the two filters clipped into the separator and flush with clean water (Fig 28)(Fig 29).
Replace by fitting the rear of the filter first then clipping the front to lock in place (Fig 30) (Fig 31).
32
33

Regular Maintenance

ALWAYS ENSURE THAT THE POWER SUPPLY IS DISCONNECTED,
PRIOR TO ANY MAINTENANCE OPERATION.
A
Remove the two hoses and disconnect the
separator from the machine (Fig 26). Undo
the separator restraining strap (Fig 26a) and
lift off the separator. The separator has a
sealing rubber which should be examined at
every clean down (Fig 27).
Rinse using clean water.
26a
29
Once emptied the top waste water tank can simply be lifted off. (Fig 32).
The clean water tank can be drained via the yellow cap fitted to the left
hand side of the machine. The cap has a rubber seal and might require a
spanner to remove. (Fig 33).
After use, empty waste water tank using
emptying hose and flush out with clean
water.
30
Avoid over tightening the clean water draining cap.
18
A
27
Note:
!
31