Regular Maintenance - Numatic TTB 1840 Mode D'emploi

!
The TTB 1840 has been designed with ease of use in mind, this included easy stripping-down and cleaning.
Fig.28
Fig.30
Remove the two filters clipped into the separator and flush with clean water (Fig.30) (Fig.30a).
Replace by fitting the rear of the filter first then clipping the front to lock in place (Fig.31) (Fig.32).

Regular Maintenance

ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
A
Fig.29
Fig.30a
Fig.33
Fig.34
After use, empty waste-water tank using
emptying hose and flush out with clean
water.
Remove the two hoses to disconnect the separator from the
machine (Fig.28).
Lift off the separator. The separator has a sealing-rubber
which should be examined at every clean down (Fig.29).
Rinse using clean water.
Fig.31
Fig.33a
The clean-water tank can be drained via the yellow cap fitted
to the left hand side of the machine. The cap has a rubber
seal and might require a spanner to remove (Fig.34).
NOTE:
Avoid over tightening the clean-water draining cap.
34
A
Fig.32
Disconnect and remove the
battery before proceeding with
tank removal (Fig.33).
Once emptied the top
waste-water tank can simply be
lifted off (Fig.33a).
!