John Bean QUADRIGA 1000 Manuel De L'opérateur page 32

A
2
1
5
6
32
B
4.1-1
4.1-2
4.1-3
3
4
8
7
4.1-1
Layout
4.1 Controls
Before operating the machine ensure that you have
properly understood the operation and function of all
the controls, as set out in this
The machine controls are located in three fundamental
units:
1- User interface (Fig. 4.1-1)
2- Control unit (Fig. 4.1-2)
3- Pedal command unit (Fig. 4.1-3)
4.1.1 User Interface
The User interface (Fig. 4.1-1) is used for entering wheel
data, selecting the type of tire and enabling/disabling
AUTOMATIC and MANUAL modes.
The panel is divided into two parts:
- a Keyboard (A, Fig. 4.1-1), for the user to operate
the software.
- a Display (B, Fig. 4.1-1), for supplying the operator
with information regarding machine settings.
Control Descriptions Figure 4.1-1
KEYBOARD Fig. 4.1-1
Key 1 and Key 2
(only in MANUAL Mode) allow you to enter data. They
are used to set the rim diameter.
The rim diameter cannot be changed after
Note:
the machine sensors have registered the
required measurements. To change the
value, you need to reset the machine, i.e.
to unclamp and then reclamp the wheel.
Press and hold down both keys simultaneously to
enable the "EXPERT CHOICE" function, used to access
the advanced Automatic Subprograms described in the
relative chapter.
Key 3 and Key 4
Reserved for Service technicians.
Key 5
Enables the automatic mounting procedure.
Key 6
Enables the automatic demounting procedure.
Key 7
MANUAL mode: press this key to exit the AUTOMATIC
mode. In any phase of the procedure this key will abort
the automated part that is operating. Remove any error
or warning messages, to continue the operation.
Key 8
Used to select the type of tire: NORMAL, SPORT, or
SOFT, see the Tire Type chapter.
Operator's Manual
chapter.
QUADRIGA 1000/BB