John Bean QUADRIGA 1000 Manuel De L'opérateur page 24

24
Introduction
STORE THIS MANUAL IN A SAFE PLACE FOR
ANY FURTHER REFERENCE. READ THIS
MANUAL THOROUGHLY BEFORE USING THE
MACHINE.
Application.
The tire changer is intended to be used as a device for
automatically demounting, mounting and beading motor
vehicle, SUV and light truck tires mounted on one-piece
rims with the following specifications:
Maximum wheel diam.:
Maximum wheel width:
Minimum wheel centre bore:
This device must be used in the application for which it
is specifically designed. Any other use shall be
considered as improper and thus not unreasonable.
The manufacturer shall not be considered liable for
possible damage caused by improper, wrong or
unreasonable use, such as working in Manual Mode.
Manuals supplied with the unit.
• Operator's Manual
(Chapter 1 – 9)
The operator must be familiar with it.
• Spare Parts Booklet
(Spare Part Table and List)
This document is for service personnel use only.
Installation instructions.
The installation instructions are in Chapter 9,
Appendices.
Operator's Manual
1200 mm (47")
432 mm (17")
40 mm
QUADRIGA 1000/BB