Mode Menu - Agilent Technologies Turbo-V 301-AG Notice De Mode D'emploi

17 Technical Information
Programming
Figure 37

Mode Menu


258/294
MODE
PUMP SETTING
INPUT / OUTPUT
SETPOINT
R1 SETTING
SETPOINT
R2 SETTING
GAUGE
SERIAL
MODE: permits selection (see Flow 1/6) of the operating mode of
the controller from those indicated below:
FRONT: accepts commands from the front panel

REMOTE: accepts commands from the remote input

connector
SERIAL: accepts commands from the serial interface (or

Profibus interface if present)
PROFIBUS: this operating mode is present only if the

Profibus interface is installed on the controller
Turbo-V 301-AG Rack Controller User Manual / 87-900-982-01 (I)
PROFIBUS
HIGH SPEED ADJ
F. 2
START MODE
R1/R2 TRESHOLD
F. 4
PRESSURE UNIT
BAUD RATE
F. 6
Flow 1/6
FRONT
REMOTE
SERIAL
F. 3
F. 5