Agilent Technologies Turbo-V 301-AG Notice De Mode D'emploi page 255

The following messages may be displayed instead of the pressure:
GAUGE ERROR: indicates that the GAUGE is not present or is not
working
PRESSURE UNDER: indicates that a pressure below the minimum
threshold set has been measured (5x10-9 mBar)
PRESSURE OVER: indicates that a pressure exceeding the maximum
threshold set has been measured (1x103 mBar)

Figure 35
Where:
CYCLE XXXX Number of start/stop cycles
TIME XXXXXm
Pressing again:
Where:
PUMP LIFE
Turbo-V 301-AG Rack Controller User Manual / 87-900-982-01 (I)
Pressing the COUNTERS key, the following is obtained:
C Y C
T I M E
P U M
X
XXXXXX
L E X
X X
LS
AG
VACUUM TECHNOLOGIES
COUNTERS MEASURES
increase
menu
decrease
LOW SPEED START/STOP
Turbo-V 301-AG
Time of last cycle (minutes)
P L I
X X X X X
total operating time (hours)of the pump
Technical Information
Use
X X X
X X X m
R1
R2
next
previous
F E
h
17
255/294