Pump Connector; J5 - Gauge Connector - Agilent Technologies Turbo-V 301-AG Notice De Mode D'emploi

Pump Connector

A five-meter long cable is available to connect the controller to the
pump. The following figure shows the controller output connector
configuration where pins:



Figura 4
J5 – Gauge Connector
This connector is available to connect the Agilent active gauges.
The pressure can be read by dispaly or by serial line (win. 224) or
by REMOTE I/O on Programmable Analog Out (see J1 – Output
connector description).
Turbo-V 301-AG Rack Controller User Manual / 87-900-982-01 (I)
A-F = pump temperature sensor
B-C-D = 75 Vac 3-phase output to pump motor stator
E = EARTH PROTECTION
Controller-to-Pump Connector
Technical Information
Programmable Analog Output Diagrams
17
223/294