TOOLCRAFT LDM 70 P Mode D'emploi page 40

• The following units are available:
Length
Area
Volume
Measurement reference
• As per the factory default setting, measurement are taken beginning
from the back of the device.
• Push the button
following measurement references are available:
•
•
•
•
•
•
•
40
Meter
m
m²
m³
(D) to change the measurement reference. The
Zero point: Back of the device
The device length is included in the measurement.
Zero point: End piece (O) on the back
Insert the end piece in the slot (H) on the back of the
device. The end piece must click into place.
The device length and end piece length are included
in the measurement.
Zero point: Front of the device
Zero point: Tripod thread (M) on the bottom
Foot Inch
ft in
ft² ft
ft³ ft
0'00" 1/16
0'00" 1/16
ft
2 2
ft
3 3