Burkert LCIE 07 ATEX 6078 X Instructions De Service page 28

The limit switch contacts are actuated via two cams no. 13 (see Figs. 1 and 2).
• The white cam is used to record the opening process (FC1).
• The black cam is used to record the closing process (FC2).
procedure:
→
Connect cable to the terminal strip 12 (see Figs.
9.2.3. multivolt or 24 V AC/DC with analogue signal
The power supply voltage of the actuator is 24 V AC/DC or 100 – 240 V AC (120 – 350 V DC).
Always observe the specifications on the rating plate!
Fig. 19: Circuit diagram
procedure:
→
Loosen left cable gland 15 and feed through the cable to be connected (see Figs.
→
Connect cable according to the circuit diagram (see Fig.
(see Figs. 1 and 2).
28
Power supply
N
100 – 240 V AC
-
(120 – 350 V DC)
1
Power supply
24 V AC/DC
+
16
Input
- 15
-
14
Feedback
+
13
English
1 and 2) according to the schematic (see Fig. 18).
Ph
+
T/E
2 3
Additional feedback
17 18
N Ph
- +
17 18
C C
A
19) to the terminal strip Pos. 14 of the power supply card
Type 3004
Installation
4-6 5
7
FC2
FC1
D
FCF
D
B
FC0
Motor
=
1 and 2).