Selecting The Display Language; Setting The Buzzer Volume; Entering The Inventory Number; Self-Monitoring Functions Overview - Hürner HST 300 Pricon+ Manuel De L'utilisateur

10.3 Selecting the Display Language

When the "Select Language" sub-menu was selected, the screen changes
to the display reproduced in Display 25.
Use the arrow keys ñ and ò to select one of the options, "Deutsch,"
"English," and "Français" and confirm your selection by pressing the
START key.

10.4 Setting the Buzzer Volume

When the "Set Volume" sub-menu was selected, the screen changes
to the display reproduced in Display 26. The buzzer can also be heard.
Turn the buzzer volume up or down to the desired value using the ï,
ð arrow keys (from 0 to 70) and confirm your setting by pressing the
START key.

10.5 Entering the Inventory Number

When the "Inventory No." sub-menu was selected, the screen changes
to the display reproduced in Display 27. Enter the identification number
under which the unit was inventorized within the company, using the
alphanumeric input routine (see section 5.11), and confirm the number
by pressing the START key.
11

Self-Monitoring Functions Overview

11.1 Errors During Data Input

11.1.1 Code Error

Erroneous input, poor code tag, error in code symbology or improper
code reading.

11.1.2 No Contact

There is no properly established electric contact between the welding
unit and the fitting (check connection terminal pushed on fitting), or the
heater coil is defective.

11.1.3 Low Voltage

The input voltage is below 180 volts. Adjust generator output voltage.

11.1.4 Overvoltage

The input voltage is over 300 volts. Decrease generator output voltage.

11.1.5 Overheated

The inverter temperature is too hot. Let the welding unit cool down for
about 1 hour.

11.1.6 System Error

CAUTION!
The unit has to be disconnected immediately from the power supply and
the fitting. The auto-test has found a system error. The unit must no longer
be used and has to be sent to an authorized shop for check and repair.

11.1.7 Temperature Error

The ambient temperature measured is outside the operating range of the
welding unit, i.e., below -20°C or over +60°C.
18
EN
All manuals and user guides at all-guides.com
HST300 Pricon+ User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
CHOOSE LANGUAGE
>Deutsch
English
Francais
ADJUST VOLUME
0-----35-----70
Turn up
Turn down
Inventory No.
*****************
Version January 2009
Display 25
à

Display 26
Display 27