Publicité
Purge Valve Installation
A gas purge valve is available to protect the pump bearings against
particulate and corrosive gases that could move into the pump.
To install the gas purge valve it is necessary to unscrew the purge
port cover as shown in the following figure,
Figure 54
and then screw the gas purge valve (with a torque of 2.5 Nm) as
shown in the following figure.
Figure 55
TwisTorr 804 FS User Manual / 87-901-052-01
Technical Information
Purge Valve Installation
17
321/344
Publicité
Chapitres
