Adjusting The Carrying Straps; Trial Run; Mixing Spraying Agents And Filling The Spraying Agent Tank - Solo 417 Instructions D'emploi

disconnect the charging cable from the charging
socket on the pressure sprayer.

6.4 Adjusting the carrying straps

Clip the carrying straps into the clips (6) on both
sides and lift the pressure across your shoulders.
Use the sliding clips to adjust the shoulder straps
to the right length.
Pull the loose ends of the carrying straps to tighten
them.
Lift up the two sliding clips again to release the
straps.
When adjusting the straps, ensure that the back
panel fits snugly and securely against the back of
the person wearing the pressure.

6.5 Trial run

At the first start-up, at the start of the spraying
season and in frequent use at least once a month,
perform a trial run according to section 9.2 to check
the entire device.
6 Preparing the device for use / 7 Mixing spraying agents and filling the spraying agent tank
7 Mixing spraying agents and
filling the spraying agent tank
When handling the spraying agents, always
follow the safety instructions of these
operating instructions (pay special attention to
section 3.4) and the information provided by the
manufacturer of the particular spraying agent.
Before opening the spraying agent tank,
switch off the pump, unplug the charger from
the charging socket of the device and depressurise
the device! To depressurise the device, with the
pump switched off, hold the spray tube in the
spraying agent tank or in a suitable container for
the spraying agent and operate the shut-off valve
until no more fluid is sprayed.
Spraying agent volume:
Mix the spraying agents according to the
instructions provided by the manufacturer of the
spraying agent. Choose the appropriate volume
according to requirements.
Mixing spraying agents:
Only mix spraying agents out in the open. Never do
this inside living spaces, stables or in storage
spaces that are used for food or animal feed.
Never mix the spraying agent directly in the
spraying agent tank.
Spraying agents in powder form:
 Mix the spraying agent in a separate container,
not in the spraying agent tank.
 Ensure that the mixture is thoroughly mixed
before pouring it through the filling strainer into
the spraying agent tank.
 Use the spray tube to thoroughly mix the
spraying agent in the tank.
Liquid spraying agents:
 Fill 1/4 of the spraying agent tank with clean
water.
 Then pre-mix the spraying agent with clean
water in a separate container according to the
instructions provided by the manufacturer of the
spraying agent.
 Pour the pre-mixed spraying agent through the
filling strainer into the spraying agent tank.
 Top up with the required amount of clean water
according to the manufacturer's instructions.
 Use the spray tube to thoroughly mix the
spraying agent in the tank.
When using spraying agents that have been mixed
from herbal preparations, the liquid needs to be
pre-filtered before pouring it through the filling
strainer, as otherwise the strainer may become
blocked.
ENGLISH 11