Assembly Of Misting Equipment; Adjustment Of Shoulder Straps - Solo Port 423 Instructions D'emploi

Assembly of misting equipment; Adjustment of shoulder straps
Completely assemble the mistblower before its first use.

Assembly of misting equipment

Attach the blower elbow (1) to the blower housing and secure with both screws (Fig.3D; A+B). Push
pleated hose onto blower elbow and secure with clamp (4).
Assembly of handle, spray tube and spray nozzle
Push handle (5) onto spray tube (start from the front) and fix in the required position (Fig.3C). A guide (7)
on the spray tube will ensure vertical positioning.
Push the spray tube with twist coupling (11) into the pleated hose (5) until locked. Secure with clamp (8).
Note: The spray tube can be twisted and turned in the pleated hose with the handle. Ensure that all hose
and cable connections are safe and without sharp bends.
Place spray nozzle (9) on to spray tube (vertical to handle) and secure (10).
Push formula delivery hose (2 pieces) on nipple of the handle and to the spray nozzle. Secure the hose
alongside the pleated hose. Shut on/off tap (vertical position), fill some plain water in formula tank and
check for any leakage.
Fig. 4
ENGLISH 10
8. Assembly of misting equipment

9. Adjustment of shoulder straps

Place the mistblower on the back and connect to
quick couplings on either side.
The straps can be adjusted to the required length with
friction slides. Simply pull down both strap ends to
tighten straps (a).
Strap tension can be released by lifting both friction
slides (b).
Note:
The shoulder straps are correctly adjusted when the
back plate of the mist-blower rests firmly against the
back of the operator.
Fig. 3