Settings - Wohler WA 335 Instructions De Service

10

Settings

Seven different parameters are available in the Settings mode:
NOTE!
If a setting applies solely to a special probe, then the corresponding parameter will only
be displayed when that probe is connected to the device.
Parameters
P10
Delete all data (CLr)
P20 Test pH probe
P30 Review calibration values
P40 Review cell constant
P50 Setting for conversion factor
Cond. >TDS
P60 Applies only to O
(not in scope of supply)
P70 Setting the temperature unit
•
•
•
•
•
pH
x
x
probe
2
x
To access the Settings mode, press and
hold the SET key for 2 seconds when the
device is powered on.
In the Settings mode, press the arrow key to
move from one parameter to the next (P10,
P20 etc.).
Press the Enter key when the parameter is
selected to access the different options
(P22, P23 etc.).
Use the arrow keys to select the desired
settings.
To exit the Settings mode and return to the
Measuring mode without saving the settings
press the ESC key.
EC O2
x x
x
x
x
x
x
Settings
Default setting
No
100 %
146.6 µS/cm,
1413 µS/cm
12.88 mS/cm,
51.5 mS/cm
1.00
0.5
Fast
°C
EN
65