Publicité
Les langues disponibles
Les langues disponibles
Mise en service et fonctionnement
4.8.7.2.2
4-50
MPIP sarl - 94, rue Mohamed Tounsi - 16013 - ROUIBA - ALGERIE
Tél./Fax : 021 81 11 22 - GSM : 070 91 75 15 ou 072 900 654 - E-mail : mpip@mpi-dz.com
Functions
The setting possibilities via SIMATIC PDM and the views of the results
are listed below:
Identification
Specifications on operating reliability:
S
day, description and message
Specifications for the device, among others:
S
Product name, serial number and ordering information, SW and HW
revision
Input
Specifications on the measuring method:
S
calibration factor, unit, component name, scanning interval,
measuring range
Output
Output calibration:
S
Redefinition of the output range for the application (related to the
unit in the output signal)
Output signal:
S
Redefinition of the unit for the application, furthermore filter time
constant for attenuation of the interference suppression,
parameterizable failure behavior, e. g. set equivalent value.
Output limit values:
S
Setting the alarm and warning limits
Settings by menus or methods
Simulation: Here the measured value (primary variable) or the whole
S
device including output section can be simulated.
Certificates and licenses
Setting whether or not the transmitter is to be operated in the
S
intrinsically safe range.
View of the measured values and diagnostic
Register for measured values:
S
Primary variable (main measured value) related to the parameter
settings which have been described in the section "Input" (see
above).
Register for output values:
S
Converted primary variable (main measured value and
channel--related measured values) as described in section "Output".
Measured value calibration and output calibration have been
performed. The output value with status is sent cyclically to the
process control system.
Dispositif de mesure de conductivité SIPAN 32
C79000-B5477-C045-02
Publicité
Chapitres
