Siemens SIPAN 32 Instructions De Service page 110

Mise en service et fonctionnement
;---------------------- Description of device related diagnosis: ------------------------------------------
;
Unit_Diag_Bit(16) = "Status appears"
Unit_Diag_Bit(17) = "Status disappears"
Unit_Diag_Bit(24) = "Hardware failure electronics"
Unit_Diag_Bit(25) = "Hardware failure mechanics"
Unit_Diag_Bit(26) = "Motor temperature too high"
Unit_Diag_Bit(27) = "Electronic temperature too high"
Unit_Diag_Bit(28) = "Memory error"
Unit_Diag_Bit(29) = "Measurement failure"
Unit_Diag_Bit(30) = "Device not initialised"
Unit_Diag_Bit(31) = "Device initialisation failed"
Unit_Diag_Bit(32) = "Zero point error"
Unit_Diag_Bit(33) = "Power supply failed"
Unit_Diag_Bit(34) = "Configuration invalid"
Unit_Diag_Bit(35) = "Restart"
Unit_Diag_Bit(36) = "Coldstart"
Unit_Diag_Bit(37) = "Maintenance required"
Unit_Diag_Bit(38) = "Characteristics invalid"
Unit_Diag_Bit(39) = "Ident_Number violation"
Unit_Diag_Bit(55) = "Extension available"
;--------------------------------------------------------------------------------------------------------------------------------------------------
;
;Modules
;
;"short formats (Identifier bytes)"
;
;"AI1, AI3, DO"
Module = "Conductivity, temp., 7MA2xxx"
EndModule
Module = "dis. Oxygen, temp., 7MA30xx"
EndModule
Module = "pH--value, temp., 7MA10xx"
EndModule
Module = "ORP--value, temp., 7MA10xx"
EndModule
;
;"AI1, AI2, AI3, DO"
Module = "pH-- +ORP--value, temp., 7MA11xx" 0x94, 0x94, 0x94, 0x00, 0xA1
EndModule
Module = "2x pH--value, temp., 7MA11xx"
EndModule
Module = "2x ORP--value, temp., 7MA11xx"
EndModule
4-64
MPIP sarl - 94, rue Mohamed Tounsi - 16013 - ROUIBA - ALGERIE
Tél./Fax : 021 81 11 22 - GSM : 070 91 75 15 ou 072 900 654 - E-mail : mpip@mpi-dz.com
0x94, 0x00, 0x94, 0x00, 0xA1
0x94, 0x00, 0x94, 0x00, 0xA1
0x94, 0x00, 0x94, 0x00, 0xA1
0x94, 0x00, 0x94, 0x00, 0xA1
0x94, 0x94, 0x94, 0x00, 0xA1
0x94, 0x94, 0x94, 0x00, 0xA1
Dispositif de mesure de conductivité SIPAN 32
C79000-B5477-C045-02