WALTHER PILOT PILOT GM 1030P Instructions De Service page 95

VERSION 12/2020
OPERATING MANUAL
10.7 CHANGING SHAPING AIR REGULATOR 110
1. Flush and clean the spray gun in accordance with Chapter 8.1.3.
2. Relieve the pressure of the product pressure generator and of the spray gun in
accordance with Chapter 7.4.
Disassembly:
1. First, unscrew grub screw (C) with a size 1.5 Allen wrench and pull air shape regulator
top piece (D) out from the rear.
2. Unscrew threaded sleeve (B) with a size 13 wrench.
If the air adjustment knob (G) gets stuck with the gun housing when unscrewing,
screw it back in and completely unscrew the threaded sleeve (B).
3. If necessary, pull out the rod seal (A) with a small screwdriver and then replace it
with a new one.
Assembly:
1. Carefully insert rod seal (A) in the foreseen notch on the gun. Ensure that the
installation position is correct (see sectional view). Ideally, place the rod seal (A) on a
flat surface and press gun body onto the seal without tilting it.
2. Coat the threaded sleeve (B) with Loctite® 542 (E) and Vaseline (F) and then tighten
it with a size 13 wrench and a torque of 9 Nm.
B_07140
3. Lock air shape regulator top piece (D)
in the position shown on the right, with
completely opened air shape regulator
using grub screw.
DOC2422648
E
F
A
9 Nm; 6.64 lbft
B
C
D
G
PILOT GM 1030P
B_07141
38