Installation; Dip Switch Settings; Preparation; Address Settings - Comelit DOME IR PTZ Guide D'utilisation

vertical directions, according to the speed the user sets in the menu.
Power Off Memory
This feature allows the dome to resume its previous preset or status after power is restored. By
the default setting, the dome supports power up memory, which improves reliability and avoids
repeated settings of the previous parameters.
Park Action
If the dome is not operated within the user-set time, it will automatically run a specific mode (pan
scan, A-B scan, tour, preserve action etc.).
Multilanguage OSD Menu
The language used for the on screen menu can be set to one of several available languages -
English, Spanish etc.

2 Installation

2.1 DIP Switch Settings

2.1.1 Preparation

Before installation, make sure that the protocol, baud rate and address code used by the product
is fully consistent with the control system. Corresponding DIP switch settings can be seen below.
The access plate for the DIP switches is located just above the camera lens opening on the
outside of the camera:
NOTE:
It is much easier to set the communication parameters using the on-screen menu rather
than the DIP switches.

2.1.2 Address Settings

DIP switch SW1 is used to set the address of the camera. It is an 8-bit switch. The number value
of switch 1 = 1, switch 2 = 2, switch 3 = 4, switch 4 = 8, switch 5 = 16, switch 6 = 32, switch 7 =
64 and switch 8 = 128. The values of all switches which are in the ON position are added to
determine the address (see illustration below). As an example, if the 1st and 3rd switches are
allocated to the ON position, the binary code is 00000101, so the corresponding address is 5
9