Güde GFO 1801 Traduction Du Mode D'emploi D'origine page 29

TECHNICAL DATA
Item number:
Voltage:
Frequency:
Protection class:
Motor output (P1):
Table saw
cutting height (at 45°):
Cutting height (at 90°):
Chop saw
Cutting range (at 45 °/45 °):
Cutting range (at 90°/90 °):
Saw blade speed:
Ø of the saw blade:
Saw blade bore:
No. of teeth:
Table width:
Table length:
Dimension LxWxH:
Net weight:
Gross weight:
Noise Details
Sound pressure level L
pA
Sound power level L
WA
Measured according to EN 61029;
Uncertainty K = 3dB (A)
Only use the machine after you
have carefully read and under-
stood the operating instructions.
Observe all safety instructions contained in these
operating instructions. Act responsibly towards other
people.
If there is any doubt about connecting and operating
the machine, contact customer service.
You should keep all documentation so that anyone
using the saw can refer to it at any time.
INTENDED USE
The table, chop and mitre saw is suitable for perfor-
ming longitudinal, cross-sectional, chopping and
mitre cuts of wood and soft plastics. Round materials
(pipes, logs, etc.) may not be cut with the machine.
Cutting metals is not permitted. This machine may
only be used as directed. The manufacturer cannot
be held responsible for any damage resulting from
non-compliance with the provisions of the generally
applicable regulations and the provisions of these
operating instructions.
GFO 1801
55173
230 V~
50 Hz
II
S1 1800 W / S6 20% 2000 W
max. 50 mm
max. 70 mm
105 x 40 mm
160 x 80 mm
4200 min-1
254 mm
30 mm
60
558 mm
500 mm
820 x 750 x 1250 mm
35 KG
41.2 Kg
91.9 dB(A)
104.9 dB(A)
SAFETY INSTRUCTIONS – GENERAL
Only operate with PRCD (portable
residual-current operated device)!
• CAUTION! Keep the work area clean and tidy.
Untidy workplaces and workbenches increase the
risk of accidents and injuries.
• CAUTION! Pay attention to the environmental con-
ditions in which you work. Do not use power tools
and machine tools in humid or wet environments.
Provide sufficient lighting. Do not expose electrical
tools to rain or high humidity. Do not switch on
electrical tools in an environment with easily flam-
mable liquids or gases.
• CAUTION! Don't let any strangers near the ma-
chine. Visitors and observers, especially children,
sick and frail persons, should be kept away from the
workplace.
• CAUTION! Make sure tools are stored safely. Tools
which are not used must be stored in a dry place as
high as possible or somewhere inaccessible.
29
GFO 1401
55174
230 V~
50 Hz
II
1400 W
max. 40 mm
max. 52 mm
40 x 85 mm
80 x 130 mm
5000 min-1
216 mm
30 mm
40
390 mm
460 mm
680 x 620 x 960 mm
27 kg
31.2 kg
92,6 dB(A)
105,6 dB(A)