Trebs COMFORTCOOK 99333 Mode D'emploi page 40

This product with intelligent control program; it will stop automatically after a pasta-made period. If you want to continue to use,
please wait for 20-30 minutes, until the motor is cool, this method help to extend the product life.
It is forbidden to use beyond capacity.
Be sure to operate in strict accordance with recommended ratio of flour and water.
Abnormal failure caused by not operating according to manual is out of the scope of warranty.
Pasta making process
1. Open the top cover
2. Measuring flour: measuring standard; please use the cleaning scraper lever the flour. The flour quantity is subject the flat
cups.
3. Measuring water: please put the water measuring cup on the flat table, check the scale line from a horizontal viewing
4. Pour flour into the mixing bowl
5. Insert the top cover to the right place in body.
6. Connect to power; press "On/Off" button.
Press button "cup 1 , 2, 3 or 4" according the flour amount. When the mixing axle start moving, pour proper amount of water
into mixing bowl, according to the ratio of flour and water in reference table.
7. After about 10 minutes, the machine alarm, pasta making are finished automatically.
Tips: the holes in the top cover cannot be choked, they must be able to drip water slowly.
Please mix eggs together with water to measure when making egg pasta. Do not add the mixture into flour directly.
ATTENTION: Do not use vegetables blended but only juice .
8. Extra Ravioli Tool
The machine is equipped with an accessory to make ravioli.
a + b) Choose dumpling wrapper discs thickness 0.8mm or 1.2mm, spread a thin layer of dough on a shelf and cut out the shape
of the ravioli with the accessory.
c) Place the paste form that is obtained directly on the accessory and fill with desired filling.
d) Close the accessory matching the sides, lightly press.
e) Remove the ravioli when ready.
4
DISASSEMBLE INSTRUCTIONS
Disassemble steps:
Be sure to turn off the machine and disconnect the power before disassembling.
1. Unscrew the screw nut (part 4) in a counterclockwise direction and take out the disc.
2. Take out the extruding axle and extruding head.
3. Press the top cover hook, lift the end surface of top cover, and remove it.
4. Unlock the fastening plate in a counterclockwise direction.
5. Take out the mixing axle.
6. Take out the mixing bowl.
40