Front Brake Lining Control; Brake Disc Thickness Control - Betamotor RR 2T 50 Mode D'emploi

4

FRONT BRAKE LINING CONTROL

To check the wear of the front brake pads,
visually inspect the caliper from below. The
lining on the visible ends of the two brake
pads should be at least 2 mm thick.
If this layer is thinner than 2 mm, replace
the pads immediately.
Note:
Perform the check according to the times
shown in the table on page 56.
To replace, contact authorised Betamotor
2 mm
customer service.
BRAKE DISC THICKNESS
CONTROL
Periodically verify disc condition. In case
signs of damage , veins, or deformations
are present, proceed with replacement.
Verify disc thickness. The minimum thick-
ness is engraved on the disc.
Once the limit is in proximity or has been
reached, proceed with brake disc replace-
ment.
For replacement, contact an authorised
Betamotor after-sales service centre.
EN
45