Rear Brake Lining Control; Brake Disc Thickness Control - Betamotor RR 2T 50 Mode D'emploi

4

REAR BRAKE LINING CONTROL

To check the wear of the rear brake pads,
visually inspect the caliper from below. The
lining on the visible ends of the two brake
pads should be at least 2 mm thick. Should
the lining be thinner, immediately replace
the brake pads.
Note:
Perform the check according to the times
shown in the table on page 16.
To replace, contact authorised Betamotor
2 mm
customer service.
BRAKE DISC THICKNESS
CONTROL
Periodically verify disc condition. In case
signs of damage , veins, or deformations
are present, proceed with replacement.
Verify disc thickness. The minimum thick-
ness is engraved on the disc.
Once the limit is in proximity or has been
reached, proceed with brake disc replace-
ment.
For replacement, contact an authorised
Betamotor after-sales service centre.
EN
47