Checks Before And After Use; Breaking In - Betamotor RR 2T 50 Mode D'emploi

2

CHECKS BEFORE AND AFTER USE

For safe driving and long vehicle life you should:
1 Check all fluid levels.
2 Check the correct operation of the brakes and brake pad wear (page 45).
3 Check pressure, general condition and thickness of tread (page 51).
4 Check that the spokes are properly tightened.
5 Check the tensioning of the chain (page 52).
6 Check the adjustment and the operation of all the cable controls.
7 Inspect all the nuts and bolts.
8 With the engine running, check the operation of the headlight, the rear and brake
lights, the indicators, the warning lights and the horn.
9 Wash the motorcycle thoroughly after off-road use (page 54).

BREAKING IN

Breaking in takes approximately 500 km/350 miles. During this time:
- Avoid travel at high speeds
- Change speed often so that the parts will break in uniformly and in a shorter time
- Avoid turning the throttle more than 3/4 of the way.
WARNING:
• After the first 500 km/350 miles, change the gear oil.
• After the first off-road use, check all of the nuts and bolts.
EN
32