Check And Adjusting Of Steering Play; Tyres - Betamotor RR 2T 50 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 125
4
CHECK AND ADJUSTING OF
STEERING PLAY
Periodically check the play in the steering
sleeve by moving the fork back and forth
as shown in the figure. Whenever you feel
play, adjust as described below:
- Unscrew the screws A
- Loosen nut B
- Take up the play by means of ring nut C
For reassembly, proceed in the reverse
order.
NOTE: Correct adjustment, in addition to
A
not leaving any play, should not cause diffi-
culty or irregularity in turning the handlebar.
B
C

TYRES

Only fit tyres approved by BETAMOTOR.
Unsuitable tyres can adversely affect the road holding of the vehicle.
• To protect your safety, immediately replace any damaged tyres.
• Slick tyres adversely affect the road holding of the vehicle, especially on wet roads
and in off-road riding.
• Insufficient pressure results in abnormal wear and overheating of the tyres.
• The front and rear tyres must have the same tread design.
• Always measure the inflating pressures when the tyres are cold.
• Keep the tyre pressures within the prescribed range.
EN
51

Publicité

Table des Matières
loading

Table des Matières