Front Brake; Rear Brake - Betamotor ALP 4.0 Mode D'emploi

FRONT BRAKE

Check
To check the wear of the front brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from the front. The
brake linings should be at least 2 mm thick.
If the linings are thinner, replace the pads
immediately.
Note:
Carry out the control procedure respect-
ing time intervals and mileage indicated
on the chart on page 141.

REAR BRAKE

Check
To check the wear of the rear brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from above. The
brake linings should be at least 2 mm thick.
If the linings are thinner, replace the pads
immediately.
Note:
Carry out the control procedure respect-
ing time intervals and mileage indicated
on the chart on page 141.
ALP
MOTARD
131
3
GB