Date And Time Adjustment; Accessories; Softener - Astoria Plus4You Manuel D'utilisation

13.5 Date and time adjustment

In this section it is possible to set the date and
time shown on the machine's display.
Scroll the menu until the item is highlighted
"4 CLOCK SET UP";
1 COUNTERS
2 SERV.BOILER PRESS
3 CUP HEATER TEMP.
4 CLOCK SETUP
Confirm the selection by pressing the ENTER key
and the display will show the following:
CLOCK SETUP
HH:MM GG-MM-AAAA D
AUTO
The value to be changed will flash.
To change the value, press the ( ) key or ( ) key.
To move to the next or previous parameter, press
the ( ) key or ( ) key, and repeat the modification
process.
To confirm and exit the menu, press the ENTER
key.
1 COUNTERS
2 SERV.BOILER PRESS
E
nter
3 CUP HEATER TEMP.
4 CLOCK SETUP
HH hours
MM minutes
DD day
MM month
YYYY year
D day of the week
AUTO The clock automatically switches to the Daylight
Saving time and vice versa.
MANUAL The clock doesn't switch to the Daylight Saving
time and vice versa.
Legend
User manual
14

14.1 Softener

the build-up of lime scale deposits in the boiler and
other parts of the machine. The softener makes it
possible to eliminate or substantially reduce the
E
nter
presence of these mineral salts. The resin softener
has the property of retaining the calcium contained
in the water. For this reason, the resins become
saturated after a certain period and must be re-
generated with coarse kitchen salt (NaCl, sodium
chloride) or special water softening salt. It is very
important to regenerate the softener within the
E
nter
established times. The regeneration is to be done
regularly every 15 days. However, in locations where
E E
nter nter
water is very hard, it will be necessary to regenerate
it more frequently. The same rule can be applied to
E
nter
locations where there is a large consumption of hot
water for tea or other uses.
1 Monday
2 Tuesday
3 Wednesday
4 Thursday
5 Friday
6 Saturday
B
7 Sunday
E

Accessories

Mains water contains insoluble salts, which cause
Softener regeneration
Proceed as follows:
move levers (B) and (E) from left to right;
remove the lid by loosening the knob (A);
release enough water through the pipe (C) to
make room for the salt to be added, based on
the model (see the table on the following page);
clean any salt or resin residues from the gasket
located on the cover;
put the cover back in place by screwing the knob
(A) down securely and move the lever (B) back
from right to left;
let the salt water drain from the little hose (D)
until the water is no longer salty (about 30-60
minutes). The salt allows the accumulated min-
eral salts to be released;
switch the lever (E) from right to left back to its
initial position.
A
C
D
47