Services Boiler Pressure Adjustment; Cup Heater Adjustment - Astoria Plus4You Manuel D'utilisation

13.3 Services boiler pressure adjustment

In this section it is possible to modify the pressure
of the services boiler (hot water / steam).
Scroll the menu until the item is highlighted
"2 BOILER PRESSURE";
1 COUNTERS
2 SERV.BOILER PRESS
3 CUP HEATER TEMP.
4 CLOCK SETUP
Confirm the selection by pressing the ENTER key
and the display will show the following:
BOILER PRESSURE
1,2 Bar
The value of the pressure will flash.
To change the pressure (from 0 to 1.4 bar), press
the ( ) key or ( ) key.
To confirm and exit from the adjustment mode,
press the ENTER key.
1 COUNTERS
2 SERV.BOILER PRESS
E
nter
3 CUP HEATER TEMP.
4 CLOCK SETUP
46

13.4 Cup heater adjustment

This menu allows the user to adjust the operating
temperature of the cup heater or switch it off.
Scroll the menu until the item is highlighted
"3 TEMP. CUP HEATER" is highlighted;
1 COUNTERS
2 SERV.BOILER PRESS
3 CUP HEATER TEMP.
4 CLOCK SETUP
E
nter
Confirm the selection by pressing the ENTER key
and the display will show the following:
E
nter
E
nter
The value of the temperature will flash.
To change the temperature (from 70 to 114 °C),
press the ( ) key or ( ) key.
To confirm and exit from the adjustment mode,
press the ENTER key.
E
nter
i
i
i
CUP HEATER
85 .C
1 COUNTERS
2 SERV.BOILER PRESS
3 CUP HEATER TEMP.
4 CLOCK SETUP
If a temperature above 114°C is set, the indication
CUP HEATER ON will appear on the display and
the cup heater will be activated in continuous
operation.
Setting a temperature lower than 70°C; the display
will show the indication CUP HEATER ---, and the cup
heater will be deactivated.
To turn the cup heater on and off, refer to
chapter 8.2.
E
nter
E
nter
E
nter
User manual