11.2 Autosteamer function
Proceed as follows:
Immerge the tips of the autosteam-
er (13) into the beverage;
press the
or
on the dose of milk in the jug;
wait until the dispensing is finished;
when the dispensing is finished,
the milk will be foamed and heated at the preset
temperature.
To stop delivery in advance, press the same key
again;
to prolong steam delivery, hold down the se-
lected dose key.
For more or less froth, adjust the special regulator
(10). Turning it clockwise will decrease the froth,
while turning it counterclockwise will increase
the froth.
The autosteamer foaming is factory-adjusted du-
!
ring the testing phase of the machine. Therefore,
it is recommended to modify the adjustment only
if strictly necessary.
User manual
13
key, depending
11.3 Heating function
Proceed as follows:
Immerge the tips of the autosteamer (13) into
the beverage;
press the
wait until the dispensing is finished;
once the delivery is finished, the milk will be
heated at the programmed temperature, but
not foamed.
To stop delivery in advance, press the same key
again;
to prolong steam delivery, hold down the se-
lected dose key.
11.4 Manual steam function
This control allows the user to use the autosteam-
er nozzle manually like a normal steam nozzle.
Proceed as follows:
Immerge the tips of the autosteamer (13) into
the beverage;
press the
To stop delivery, press the same key again.
11.5 Automatic autosteamer nozzle cleaning
After 120 minutes of idle time the automatic
cleaning of the nozzle starts, lasting 15 seconds.
The following message will appear on the display:
10
"STEAM CLEANING CYCLE"
A minimum amount of steam will come out of
the nozzle.
i
The system includes a time limit of a maximum of
4 minutes for autosteamer operation.
key;
key;
43