Rotation Of The User Interface; Figure 14: Positions Of The User Interface; Figure 15: Changing The Position Of The User Interface - DAB EVOSTA2 Mode D'emploi

15.2.1 Positioning of the user interface in heating systems
It is possible to position the user interface with the cable facing to the left, to the right, or upwards.

15.3 Rotation of the user interface

If the circulator is installed on pipes in a horizontal position, it will be necessary to rotate the interface with the respective electronic
device through 90 degrees in order to maintain the grade of IP protection and to allow the user a more convenient interaction with the
graphic interface.
Before rotating the circulator, ensure that it has been completely drained.
To rotate the EVOSTA2 SOL circulator, proceed as follows:
1. Remove the 4 fixing screws of the circulator head.
2. Rotate the motor casing with the electronic control device through 90 degrees clockwise or counterclockwise, as necessary.
3. Reassemble and tighten the 4 screws that fix the circulator head.
The electronic control device must always remain in vertical position!
ENGLISH

Figure 14: Positions of the user interface

Figure 15: Changing the position of the user interface

51