Start; Table 5: Mounting The Evosta2 Connector - DAB EVOSTA2 Mode D'emploi

Phase
Unscrew the cable gland nut and
Action extract the terminal board from
the connector.
Illustration
Phase
Insert the wired terminal board in
Action the cable gland.
Screw on the locking nut.
Illustration

10. START

All the starting operations must be performed with the cover of the EVOSTA2, EVOSTA3 control panel
closed.
Start the system only when all the electrical and hydraulic connections have been completed.
Avoid running the circulator when there is no water in the system.
As well as being at a high temperature and pressure, the fluid in the system may also be in the form of
steam. DANGER OF SCALDING!
It is dangerous to touch the circulator. DANGER OF SCALDING!
ENGLISH
EVOSTA2
1
Remove the retaining screw.
4
Connect the wired connector to the
pump and tighten the retaining
screw.

Table 5: Mounting the Evosta2 connector

42
2
Fit nut and connector on the cable.
Strip the wires as indicated in the
figure. Connect the wires to the
terminal board, respecting the phase,
neutral and earth.
5
3