Works Settings Of The Control Electronics - Burkert 8605 KK Instructions De Service

8.3.11 end
To quit the respective menu level, select the menu item END with the arrow
keys.
The settings made are saved on leaving the configuration menu.
SP s Hz %
HI
PV
mA V
LO
,
Illustration
8-15: End
8.4 Works Settings of the control electronics
Menu item
InP
Out / VALV
Out / VAdJ
Out / AdJ
deLY
Cut
PArA
Addr
SPOS
40 - 8605
factory setting comment
0 ... 10 V input signal 0 ...10 V selected
- - - - no valve selected
OFF manual fine tuning of the valve fre-
quency inactive
LO: 2 mA these values are changed by a valve
selection
HI: 200 mA
LO: 0.0 s ramp function inactive
HI: 0.0 s
LO: 2.0 % zero point cut-off active at 2 %
SEt2 controller parameter set 2 selected
0 Address 0 for the serial communica-
tion selected
0.0 % Safety setting 0 % at an input signal
below 4 mA (with selection of the
4 ... 20 mA input signal) selected