Timer Operation; Wiring Diagram - BWT Soliflow Notice D'installation Et Conseils D'utilisation

14.

TIMER OPERATION

Set the timer to the right time by synchronizing the wheel to the current time. Insert a screw driver into the
centre of the wheel to position the needles similar to the hands on a watch: the big needle corresponds to
the minutes, the small hand shows the hours).
Next, rotate the ring until the time is aligned with the pointer. In a figure, the setting corresponds to 10 am.
To define the switching intervals (the intervals during which filtration should run), push the relevant
segments toward the exterior of the timer dial as shown in a figure. Each segment represents minutes.
Lastly, turn the rotary switch to the desired mode:
O = stopped (out)
= Automatic (filter runs during the intervals set on the timer)
I = forced on (in)
15.

WIRING DIAGRAM

Mains, 230 V
ALIMENTATION
RESEAU (230V)
FILTRATION BWT myPOOL
INSTRUCTIONS FOR USE
A 1
A 2
A 3
FILTER PUMP
P O M P E F IL T R A T IO N
4 5 0 W
2 3 0 V
M O N O
1 -ph
B 5 B 6 B 7
B 4
C O N D E N S A T E U R (8
CAPACITOR 8 µF
(6 µF for 60 Hz motors)
QUICK FIT CONNECTOR
CONNECTEUR RAPIDE
µF )
2020/02 - Indice de révision : H - Code : 26901
33/40