Troubleshooting For Users; Exceeding The Heating Period; Light Does Not Operate; Low-Water Display - Sentiotec K3 NEXT Instructions De Montage Et Mode D'emploi

Instructions for use for the user

12. Troubleshooting for users

Refer to Fig. 6 (page 22).

12.1. Exceeding the heating period

Problem: "00.00" is flashing in the display 2.
Cause: After running for 6 hours, the sauna control unit automatically switches
off the sauna heater for safety reasons (heating period limit).
How to solve the problem:
To start up the sauna control unit again, press and release the time button 9.
► The sauna heater is switched on and begins to heat up.
► The display 2 and control lights 1 and 3 light up according
to the operating mode.

12.2. Light does not operate

How to solve the problem:
1. Switch off the sauna control unit using the ON//OFF switch 8.
2. Switch off the main fuse of the sauna control unit in the fuse box.
3. Change the bulbs used for lighting the sauna.
4. Switch the main fuse back on.
5. Press switch 7.
► If the light still does not operate, inform your supplier.

12.3. Low-water display

The sauna control unit features an automatic low-water display which is active
in combi mode, as long as your combi heater supports this function.
Problem: "FILL" is flashing in the display 2.
Cause: The water tank in the evaporator is empty.
WORLD OF WELLNESS
p. 29/32
EN