Installing The Bench Sensor; Installing A Door Monitor (Optional) - Sentiotec K3 NEXT Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 66
Installation instructions, only for experts

4.4. Installing the bench sensor

Refer to Fig. 3 (page 15) and Fig. 5 (page 21).
ATTENTION!
Sources of interference can have a negative effect on signal transmission
● Lay heater sensor wires separately from other mains wires and control wires.
● Protect wires with only one layer of insulation by using a pipe (double insulation).
The bench sensor wire may only be extended under the following
conditions:
● When a silicone cable resistant to temperatures up to 150 °C is used.
● The minimum cross-section of the wire totals 0.5 mm
● The length of the bench sensor wires must NOT exceed 10 m.
1. Lay the two 2-pin bench sensor wire 5 in the wall of the sauna cabin,
leading them to the bench sensor installation location 4 and secure
the bench sensor wires using wire clips.
2. Pull the two half-shells 1 of the bench sensor apart.
3. Connect the two connectors for the heater sensor wire in accordance with
the connection diagram (Fig. 5).
4. Carry out the tests as shown in section 4.6. Performing tests on page 17.
5. Place the connection panel 2 crossways (as shown in Fig. 3 ) in the
heater sensor half-shells 1.
6. Place the two half-shells together and screw them together using the two
cross-head screws 3 (9 mm).
7. Check whether the bench sensor has been securely closed.
8. Install the bench sensor on the wall of the sauna cabin using the two
wood screws 6 (16 mm) enclosed. The optimum position is opposite the
sauna heater. Maintain a distance of approx. 15 cm to the ceiling of the
sauna cabin.

4.5. Installing a door monitor (optional)

Install the door monitor according to the installation instructions for the product,
or the sauna cabin manufacturer's instructions.
WORLD OF WELLNESS
p. 16/32
2
.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

K3-9-n

Table des Matières