Sentiotec K3 NEXT Instructions De Montage Et Mode D'emploi page 52

Installation instructions, only for experts
e. For the vertical 10-pin connector, short-circuit pin 9 and pin 10 using
a suitable screwdriver, as shown in figure Fig. 4.
f. Pin 9 and pin 10 are the top 2 contacts.
g. Switch on the control unit.
h. The display shows P123 or P1.
i. Disconnect the connection between pin 9 and pin 10.
j. Wait about 5 seconds and then press the time button 9.
► The display 2 and control lights 1 and 3 light up according
to the operating mode.
Fig. 4
!
If a problem persists, consult your supplier.
WORLD OF WELLNESS
p. 20/32