Installation; Tools And Materials; Initial Conditions And Checks - Erreka SKY SK110E Manuel De L'installateur

INSTALLATION

1

TOOLS AND MATERIALS

Electrician's screwdriver and Phillips screwdriver 2x125
Spanner 13mm
Allen key 5mm
Marker pencil
Tape measure
2

INITIAL CONDITIONS AND CHECKS

Initial conditions of the door

Check that the size of the door is within the
admissible range of the operator (see the
technical features of the operator).

If the door to be automated has a personnel
door, use a safety device to prevent the
operator from operating with the personnel
door open.
Environmental conditions

This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

The electrical connections shall be made in line
with the instructions in the control board
manual.

The electrical cable section is indicated in: "Fig. 1
Elements of the complete installation" on page 15.
Electrical drill and broaches

Use the electrical drill in line with the user
manual.
Wall or structure support attachment screws

The door must be easy to manipulate manually,
namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its open/
close.

Do not install the operator in a door which
does not work correctly in manual operation,
as this may lead to accidents. Repair the door
before installing.

Check that the admissible environmental
temperature range for the operator is suitable
for the location.
English
SKY electromechanical operator
17