Arjohuntleigh Enterprise 9600X Notice D'utilisation page 8

WARNING
It is recommended to use the Function Lockout facility on the
Attendant Control Panel to prevent unintended movement in
situations where objects may press against the patient's controls.
When the bed is operated, make sure that obstacles such as
bedside furniture do not restrict its movement.
The bed can only be moved on firm surfaces. Gradients must not
exceed an angle of 10 degrees.
When moving or operating the bed, take care that any accessories
attached to it (e.g. lifting pole) do not strike doors, ceilings, etc.
Hold the head board or foot board when pushing or pulling the bed;
do not hold the side rails or any attached accessories.
Before operating the bed, make sure the patient is positioned
correctly to avoid entrapment or imbalance.
Take care when using equipment that needs to be positioned under
the base frame to ensure there is no contact with any part of the
bed frame or components.
Take care not to squeeze or trap trailing cables from other
equipment between moving parts of the bed.
Take care not to allow clothing or bed linen to become snagged on
moving parts of the bed.
When operating moving parts of the bed, ensure the bed does not
come into contact with adjacent equipment which could be
damaged by the beds operation.
This product complies with the requirements of applicable
standards for electromagnetic compatibility (EMC). However,
medical electrical equipment requires special precautions
regarding EMC and should be installed and used in accordance
with the EMC information in the product service manual.
Medical electrical equipment can be affected by portable and
mobile radio frequency communications equipment, e.g. cellular
telephones.
iv