Arjohuntleigh Enterprise 9600X Notice D'utilisation page 36

These buttons raise and lower the thigh section.
Thigh section
When the thigh section is first raised from the flat position, the
calf section will be in the Fowler position (angled downwards).
To change the calf section to the vascular (horizontal) position,
refer to the section "Attendant Control Panel (ACP)" on
page 31.
These buttons raise and lower the backrest.
Backrest angle
The Auto-Chair up button simultaneously raises the backrest
Auto-Chair/Bio-
Conouur
and thigh sections, pausing when the backrest reaches 45º
(the Bio-Contour position). Continue to hold the button down to
lower the foot end of the mattress platform into a chair position.
If the backrest angle is greater than 45º, it will return to 45º to
prevent the patient from tipping forwards.
The Auto-Chair down button returns the mattress platform to a
flat and level position.
These buttons raise and lower the mattress platform.
Mattress
platform height
When the mattress platform is lowered to 38cm* above the
floor, it will pause then continue to lower until it reaches its
minimum height.
* 40cm (16 ins.) on beds with 150mm (6 ins.) castors.
WARNING
At minimum height, clearance underneath the bed is reduced. Keep
your feet away from the areas below the split side rails and take
extra care when using patient hoists or similar equipment.
When the mattress platform is at minimum height, the Auto-Chair
function is not available.
28