Arjohuntleigh Enterprise 9600X Notice D'utilisation page 47

To calculate and display the patient's weight:
Weighing
1. With the patient lying centrally on the bed, press the
2. The display will show a moving circular pattern until a
3. The patient's weight will be displayed for ten seconds then
Weight readings can be viewed in pounds or kilograms by
Weighing Units
pressing the Select Units button. An indicator next to the
display will light to show the selected units (lbs or kg).
To lock the Select Units button so that the display always
shows readings in either pounds or kilograms:
Hold down the Function Lockout button. Then press and hold
the Select Units button. Keep both buttons pressed until you
hear a "beep". Check that the required indicator is lit (lbs or kg).
Normal operation of the Select Units button can be restored by
repeating this procedure.
In kg mode, weights are shown correct to the nearest 500g.
In lbs mode, weights are shown correct to the nearest 0.5lb.
The Auto Compensation facility allows weight (up to a
Auto
Compensation
maximum of 100kg, 220 lbs.) to be added to or removed from
the bed, without affecting the indicated patient weight.
1. With the patient lying on the bed, press the Auto
2. The display will show a moving circular pattern until a
3. The display will show
4. Add or remove accessories, bed linen, pillows, etc. as
5. Press the Auto Compensation button again.
6. The display will show a moving circular pattern for a few
Caution
The weighing system requires periodic calibration to ensure
accuracy. See "Preventive maintenance" on page 51.
Weigh button once.
stable weight reading is obtained.
the display will go blank.
Compensation button once.
stable weight reading is obtained.
in Auto Compensation mode.
required.
seconds then revert to showing the patient's weight.
to indicate that the system is
39