I - Initial Checks; Unpacking The Clock - Bodet Style 5 Notice D'installation Et De Mise En Service

I – Initial checks
Thank you for choosing a BODET clock.
This product has been carefully designed, adhering to ISO 9001 quality processes, to ensure your
satisfaction. We recommend that you read this manual before handling the clock.
Retain this manual for reference for the lifespan of your clock.
The information supplied is non-binding; Bodet reserves the right to make changes to equipment,
including functional, technical and aesthetic changes or changes to colours, without notice. This
manual presents all possible functions of Style clocks. These functions depend on the model of your
clock.
Failure to observe these instructions may cause irreversible damage to the clock and
invalidate the warranty.
These instructions relate to the following clocks:
Style 5: hours and minutes display. Height of digits: 5 cm.
Style 5S (seconds): hours, minutes and seconds display. Height of digits: 5 cm.
Style 7: hours and minutes display. Height of digits: 7 cm.
Style 7D (date): hours, minutes, date, day and week display. Height of digits: 7 cm; height of
letters: 5 cm.
Style 7E (ellipse): hours, minutes and revolving seconds display on ellipse design. Height of
digits: 7 cm.
Style 7S (seconds): hours, minutes and seconds display. Height of digits 7 cm.for hours and
minutes, 5 cm for seconds.
Style 10: hours and minutes display. Height of digits 10 cm.
Style 10S (seconds): hours, minutes and seconds display. Height of digits: 10 cm.
Style 10D (date): hours, minutes, date, day and week display. Height of digits: 10 cm; height of
letters: 7 cm.
Style 10SD (seconds-date): hours, minutes, seconds, date, day and week display. Height of
digits: 10 cm; height of letters: 7 cm.
These instructions relate to synchronisation of the clocks as follows:
IND (independent): The clock can be configured independently for autonomous operation.
IMP (impulse): The clock can be integrated into a time distribution network managed by a master
clock emitting impulses (minute or 1/2 minute on a parallel line).
RADIO (ALS(FI) + DCF) : The clock may be configured independently or radio-synchronised
using an external ALS(FI) or DCF or GPS antenna (optional product not included).
DHF: The clock is radio-synchronised by a DHF radio signal.
AFNOR: The clock should be installed as part of a wired coded time distribution network in
compliance with AFNOR or IRIG-B standards.

1.1 Unpacking the clock

Carefully unpack the clock and check the contents of the package. This should include:
• Style clock
• 3 or 4 screws (Ø4mm) according to the model + wall plugs Ø6mm
• Anti-static cleaning kit
• IMPORTANT: product identification label
An identification label is affixed to the back of the clock. Use the URL link shown to download these
instructions from the Bodet website: www.bodet-time.com.
4
EN