Wall Mounting - Style 10-10S-10D-10Sd - Bodet Style 5 Notice D'installation Et De Mise En Service

2.2 Wall mounting – Style 10-10S-10D-10SD
The visuals below refer to the Style 10 clock. However, the installation process shown also applies
to Style 10S. Refer to the Technical specifications on page 27 for clock dimensions.
1) Fix the wall bracket to the wall using the four (Ø4 mm) screws supplied.along with the 4 wall plugs
(Ø6 mm). Use a 6mm drill bit.
2) For cabled versions (AFNOR and IMP),
insert the power and synchronisation cables:
• From above: cut through the top of
casing u.
• From the rear: dedicated space v.
3) Attach the wall bracket to the wall, then
clip on the electronic card.
Insert the lower part of the electronic board
into the back of the wall bracket then push
the upper part of the board in towards the
back of the bracket until it clicks w.
4) For electrical connections, refer to page 11.
5) Connect the power cable to the electronic
board using a plastic tie (mounting hole
provided in the electronic board).
6) Connect the ribbon from the LED modules
(clock casing) to the electronic board x.
ATTENTION: To avoid damaging the
product, please, watch for the orientation
of the flat cable connector. For that
purpose the connector is keyed (A) and
marked (B).
7) Attach the clock to the wall bracket by
inserting the upper part of the clock into the
back of the bracket in the slots provided,
then press the clock in until it clicks.
Secure the clock to the bracket at the bottom,
using the mounting screw provided.
Ensure that the cables are not trapped
during this operation.
8) The clock may be subsequently detached from the bracket by lifting the lower part of the clock
outwards, then removing the upper part.
Important : about double face installation on support bracket, refer to the manual supports,
ref.: 607847 (included with the bracket).
u
w
A
A
B
B
EN
v
Back view
w
x
Wall bracket Style 10
+ electronic board
Right side
cutaway view
7