5.10 Filling The Water Boiler During Treatment - Wella HAIRSPA ION Mode D'emploi

5 Performing treatment
Figure 17
68
1521126, Edition 2012-11, Version 4
➥ If ionization was switched on during prior treatment, the Ion button
w lights up – ionization is switched on.
Pressing the Ion button w switches off ionization.
•
➥ The indicator light on the Ion button w goes out.
Pressing the Ion button w again switches ionization on once more.
•
3. At the end of the after-treatment, switch off the appliance as descri-
bed in "Section 5.11" page 69 or prepare for new treatment.

5.10 Filling the water boiler during treatment

5.10.1 Checking the water level in the water boiler
The water level in the water boiler 6 can easily be checked during use.
1. Push the lock of the cover 5 forwards.
➥ The cover 5 automatically opens upwards.
➥ If the appliance is switched on, a flashing symbol appears:
cover 5 open in display q.
•
➥ The treatment is interrupted.
Take the extended development time of the products into con-
sideration
• Please bear in mind that every interruption and the resulting
delay in the resumption of the treatment will extend the
development time of the hair treatment(s).
• This may lead to unforeseen and unintended consequences
and results with which the customers are not satisfied.
• Take the extended development time of the products into
consideration.
2. Read the level on the level indicator 2.
Continued on next page.
NOTE