Cleaning The Housing / Condensation Container; Cleaning / Replacing Seals - Wella HAIRSPA ION Mode D'emploi

6 Maintenance by the user
Figure 24
Figure 25
Figure 26
74
1521126, Edition 2012-11, Version 4
6.6

Cleaning the housing / condensation container

The housing and moving parts of the appliance are made of sturdy mate-
rials that are easy to clean. You will avoid discolouration if you remove tra-
ces of colouring products immediately or directly after treatment.
Do not use benzine, paint thinners, harsh cleaning agents or scouring pro-
ducts to clean the housing and the condensation container j.
1. Comply with the safety instructions in "Section 6.1" page 70.
2. Clean the appliance with a moist (not wet) cloth.
3. Remove the condensation container j from the appliance, empty
and also clean it.
The condensation container j can be cleaned in a dishwasher.
•
6.7

Cleaning / replacing seals

1. Carefully clean the soiled / furred seals with a moist (not wet) cloth.
2. Check the seals for cracks or damage and replace if necessary.
• Do not use any damaged seals!
6.7.1 Seals on the water boiler
1. Remove defective or heavily soiled seals 1/2.
2. Position new round seal 1 and press into groove.
3. Position new oval seal 2 with wide side facing outwards and press
into groove.
4. Check that seals 1/2 are securely in place.
Damage to the appliance
• Do not insert the water boiler 6 into the appliance and do
not operate the appliance if the seals 1/2 are missing, are
not properly mounted or are damaged.
5. Fill the water boiler 6 with water as described in "Section 4.3"
page 58 and insert it into the appliance.
6.7.2 Seals on the steam distributor
1. Remove defective or heavily soiled seals 1/2 from the mount 3 of
the steam distributor 3.
2. Insert two new round seals 2 into the grooves of the mount 3.
3. Fit the new seal 1 with the small opening facing the mount 3 and
push it as far as it will go onto the steam distributor 3.
The small opening of the seal 1 must be placed against the steam
•
distributor 3. The large opening must point away from the steam
distributor 3.
4. Check that seals 1/2 are securely in place.
NOTICE